The power part of socks machine mainly includes motor, electrical control box and operating element.
The transmission mechanism of the socks machine is based on the programming process of the cotton socks, and the movement is transmitted to the needle tube and the manipulator. The transmission mechanism of a single needle hose machine. Machine tool spindle is divided into machine tool spindle I and machine tool spindle II double section. Machine spindle I is equipped with swing handle l, flexible transmission belt disc, slow speed belt disc and transmission gear. Slow speed transmission belt disc according to the swing handle square pin and machine tool spindle l soil, transmission gear and machine tool spindle I are also fixed into one body, and flexible transmission belt disc and fast rate belt disc (connected with the coat simple transmission gear) are clamped to machine tool spindle l. When the transmission belt of the transmission system is in the transmission belt disc one after another, the needle tube is respectively stopped, slow speed rotation and rapid rotation. The clutch is connected to the machine spindle II according to the crescent key, and can move up and down along the machine spindle II. When the clutch is moved to the right and the left face of the transmission gear 8 is aligned, shaft l and shaft II are connected into one body, and the needle tube is rotated on one side. The transmission gear is aligned with the gear drive gear, and the gear drive gear swings according to the fan type drive gear of the crankshaft transmission system. When the clutch moves to the left side and the right side of the transmission gear, shaft I and shaft II are separated from each other, and the needle tube of the fan-type transmission gear transmission system is moved repeatedly. The fan-type transmission gear is equipped with two large and small support plates, which respectively support the push plate and the chain wheel chain, and then drive the operation organization of the socks machine. There is a transmission gear at the bottom of the needle transmission gear, which is used to drive the system rubber band transportation equipment. A camshaft is fixed on the inside side of the circular chain drive gear on the machine spindle II, which adjusts the line barrel according to the support rod drive system, and is used to replace the yarn guide when the horizontal bar is prepared.
Calculation of transmission ratio of transmission system:
When knitting different parts of cotton socks, the rotation rate and direction of the needle should be changed accordingly. There were four modes of needle movement: unilateral rapid, unilateral slow, reciprocating rapid, and reciprocating slow.
The above is the operation principle related to the maintenance of socks machine.